Has your DLink extender suddenly stopped working? There could be a variety of reasons behind it. Are you able to log in to your extender using the IP address 192.168.0.1? See if the firmware is updated to the latest version or not. An older version of firmware can also be responsible for this issue. In this article, we have covered the topmost solutions for fixing the extender that stopped working.
How to Fix D Link Extender That Stopped Working?
Here are some tips you can try to troubleshoot and potentially resolve the issue under discussion:
First Things First
- Firstly, examine the LEDs on your wireless extender. They indicate the status of the device. Refer to the extender’s user manual to learn what each LED signifies. If there are any unusual LED patterns or behavior, then this could help you understand the problem. This will help you provide clues about the issue.
- Secondly, you should also ensure that the extender is plugged into a working power outlet. The poor power supply can stop the extender from working.
- Thirdly, be certain that the D Link extender is not in range of any other WiFi networks that use the same channel.
Troubleshooting Steps
There are a few things you can do to try to fix a D-Link extender that has stopped working:
Restart the Extender
This is the simplest thing to try, and it often fixes the problem with technical devices. The first step to troubleshooting any technical device is to perform a power cycle or reboot it. To power cycle the extender, unplug it from the power source, wait for about 10-15 seconds, and then plug it back in. This can often resolve minor temporary glitches. See if the extender works now.
Verify Network Connectivity
Ensure that the extender is still connected to the main gateway or the host router. At times, it might lose its connection, causing it to stop working. You may need to reconnect it. Remove the cable that is used to connect the extender to the host router. Examine it for any damages. Replace it if it is broken or worn out. Establish the connection once again. Be very certain that the connection is finger-tight. Also, see to it that the right ports are put to use to make the connection.
Fix Router Issues
Sometimes, the problem might not be with the extender, but with your host router or the main gateway. Check that your router is functioning properly and providing a stable internet connection. Make necessary changes if required.
Change the Placement
The location of your extender matters. It should be placed within the range of your main router(in case the devices are connected wirelessly). Check the signal strength. If the signal strength is poor, then you should try moving the range extender closer to the host router.
Besides, it should be away from interference-causing devices like cordless phones, microwave ovens, and other electronic devices in the home.
Reset the Extender to Factory Defaults
If power cycling and other tips don’t work, you can try performing a factory reset. This will erase all of your customized settings. However, it can also help fix problems that are caused by any corrupted settings on the extender.
To reset the extender to factory defaults, look for the Reset button on the back or side of the device. Push and hold it for 10 seconds using a paperclip or a similar sharp pointed tool. The LED on the front of the extender will blink when it is resetting.
Bear in mind that you’ll need to reconfigure it from the very beginning after the reset is done. Follow the instructions in the user manual or the manufacturer’s website to configure the extender properly.
Additional Tip:
Update the Extender’s Firmware
Check if there are any firmware updates available for your extender. Outdated firmware can lead to compatibility and performance issues.
To update the firmware, go to the D-Link website and download the latest firmware for your extender. If you have D’Link DAP 1720 setup done, then download the firmware for this model only.
The Closing Note
This completes the troubleshooting process for your D Link extender that stopped working. We hope the extender is working without any issues now.